- 作者: Emily
- 来源:
- 日期: 2019-03-02
- 浏览次数: 1640次
Ironing machine common faults and solutions
1. Common faults: The flattening roller heats up slowly.
(1) Reason: The steam pressure is too low.
Solution: Increase steam pressure.
(2) Reason: There is water inside the main ironing roller, and the trap does not work properly.
Solution: Repair or replace the trap and let off the water from the main ironing roller.
(3), reason: The siphon is damaged or the position is wrong.
Solution: Repair the siphon.
2, common faults: the fabric is often damaged when ironing.
(1) Reason: The ironing belt is too tight.
Solution: Adjust the tightness of the ironing belt.
(2), the screed buckle has burrs.
Solution: Repair the burr
3, common faults: the machine is often tempered during the work process.
(1) Reason: The ironing belt has different lengths on both sides.
Solution: Replace the ironing belt.
(2) Reason: The springs with the tensioning shaft are not adjusted on both sides.
Solution: Re-adjust the spring tension of the tensioning shaft.
(3) Reason: The belt shaft is bent.
Solution: Replace the belt shaft.
(4) The machine level is not adjusted well.
Solution: Re-adjust the horizontal plane of the machine.
4, common fault: press the RUN button roller does not turn.
(1) Reason: The connection between the inverter and the motor is loose.
Solution: Fasten the connection.
(2) The inverter is not output.
Solution: Run the inverter after troubleshooting the inverter.
Thanks for reading more details please check www.amisfelting.com
#laundry #laundryMachine #Laundrymachinemaintain #solution #commonfault